Climate and Temperature
Product Information and Use
Peel backing off RapidStrip (RS). Attach RS to Q20 device. Peel backing off the other side of RS. Press device, with RS, firmly on mounting surface for 30 seconds. Let cure for 3 minutes. Press device firmly against the wall again before mounting cameras or other accessories to the Q20 device. Hold articulating arm firmly with one hand while tightening device with the other hand to avoid any rotation pressure on the Q20 device.
To remove from surface, place thumb and forefinger in the grips on the RapidMount Q20. Pull slowly from one side of the device, with applied pulling pressure, to release the seal on the strip. Once removed from the surface, peel off RS. When ready to use again, repeat the process with new RapidStrip.
Loosen drawstring on SLX. Peel backing off RapidStrip (RS). Attach RS to back of SLX. Peel backing off other side of RS. Press device, with RS, firmly against mounting surface for 30 seconds. Let cure 3 minutes. Press device against wall again to ensure RS adhesive is firmly attached to the surface before mounting speedlight in holder. Place speedlight in cradle, angle light as needed and tighten drawstring to secure around joint of speedlight. SLX will accommodate an attachable trigger (transmitter) under cradle or hanging from SLX arm. Modifiers can be added to speedlights. Be sure to maintain less than 1.5lbs of gear in holder.
Submit an FAQ Question
Need further assistance? For Technical Support or Customer Service, please email us at email@example.com